Make a bootable pen drive itself without any software.

How are you all? Wish you are well. Today I am going to share the trick how to make the pen drive bootable without using any software.
At first insert the pen drive to your PC ,  then from the start menu  launch the command cmd program using run. Note that, the pen is empty.Then type DISKPART command in cmd program. Then a separate window will appear , write LIST DISK and then press Enter. In the days following commands one by one.
Then use the following command one by one.

SELECT DISK 1
CLEAN
CREATE PARTITION PRIMARY
SELECT PARTITION 1
ACTIVE
FORMAT FS=NTFS
ASSIGN
EXIT

After that minimize the command then  insert. windows 7 or 8 DVD . Your DVD drive letter (example 'H') and PEN DRIVE letter (example 'I') keep in mind. In Command Window write H: CD BOOT and  CD BOOT . At last write BOOTSECT.exe / NT60  command and then press Enter. Then copy the Windows DVD's content in pendrive

Thenit is ready for your  bootable pen drive. However, this program will not work on Windows XP. (It is for Windows Vista, 7 and 8 )
Kingston Digital DataTraveler 101 Generation 2 - 32 GB Flash Drive DT101G2/32GBZET

2 comments:

Choton said...

Dear Sir, I'm Sudip from West Bengal, India. In my PC, few sites are not open due to FLASH problems. A very few sites are open occasionally. But they are taking too much time. Yahoo & Adobe sites are not open in my PC. Can you please give me a good solution for this problem. Because lots of time I'm trying to install FLASH online. But I am failed to install FLASH.

Informer said...

Install Adobe Flash Player latest version.

Post a Comment

Thanks for your your time

Note: Only a member of this blog may post a comment.